Description
RMS-300 – Remote Monitoring System
RMS-300 The Super RMS; Is a unique remote voltage monitoring, data acquisition, and control device specifically designed for use with battery powered wireless internet repeater sites, or other AC & DC powered remote equipment RMS-300 Has ultra low power consumption and won’t put a drain on your power source. Uses only 1.2 watts. RMS-300 Is powered by DC voltage from 10 to 60 volts. RMS-300 Uses embedded Ethernet technology for internet data acquisition and remote voltage monitoring. RMS-300 Allows you to monitor voltage at your home solar energy system or remote repeater site. RMS-300 Uses the LINUX operating system for versatility, stability, and security. RMS-300 Gives you the situational awareness you need to keep your equipment operational and reliable.
Main Features
- Four layer PCB with Nickel Immersion Gold plating and red solder mask.
- 400 – MHz Arm Processor (500 Mips !).
- 256 – megs of Nand Flash. Create and store custom applications.
- 64 – megs of SD-Ram.
- Hyper efficient Low Noise Switching Power Supply, accepts 8 – 60 vdc input.
- Can be powered directly from 12, 24, or 48 volt battery banks.
- Battery backed-up, real time clock.
- One onboard temperature sensor – 25c + 100c.
- Eight 24 bit isolated voltmeters (+/- 100 VDC). Each voltmeter has its own 24 bit Delta Sigma ADC.
- Four Latching Power Relays for devices using up to 240v – 15 amps AC/DC current.
- Three programmable push buttons.
- Six general purpose I/O pins.
- Five alarm input pins.
- Power output port, 5.0vdc (500ma).
- Power output port, 3.3vdc (500ma).
- One full serial port for controlling cell phones, modems, GPRS, etc.One
- console serial port for full terminal access.
- Two USB 2.0 ports for cameras, wireless clients, extra Ethernet, etc.
- Runs real Linux! 2.6.33 kernel.
- Send SMS messages, Email alerts, SNMP traps, Remote Syslog Messages.
- Ping watchdog, power cycle equipment after a set amount of ping timeouts.
- Command line utilities: ping, ftp, email, relays, etc.
- Flash new firmware over the internet.
- Dual Watchdog Reset circuits, processor integrated, and extra hardware.
- Control RMS-300 via web page, telnet, ssh, or snmp.
- Full SNMP v1, v2, v3 support (default v3).
- Supports external USB relays, voltmeters, and temperature sensors.
- Hardware is user accessible from files on the board.
- Make your own utilities and scripts to upload. (Bash, PHP, Perl, Python, Lua, TCL)
- Pluggable connectors for ease of use.