BAT-0400-M-1U Military Grade Expansion Battery Pack » Helios Power Solutions Group

BAT-0400-M-1U Military Grade Expansion Battery Pack

Brand: Synqor

SKU: BAT-0400-M-1U
Note: Serviced regions include Australia, New Zealand, Middle East, Asia.
  • Sealed, weather-proof, shock-proof construction
  • >16.5 minute run-time at full power
  • 1250W continuous output power
  • Full discharge: -40 °C to +55 °C
  • Low weight: 11.8 lbs.
  • <1U high unit (15.00” x 10.89” x 1.46”)

Description

BAT-0400-M-1U

Military Grade Expansion Battery Pack | -40 °C to +55 °C Operating Temperature

The BAT-0400-H-1U Series is a military-grade expansion battery pack that uses lithium polymer batteries and highly efficient power electronic circuitry to achieve a high power level and battery run-time in a low-profile, low-weight, rack-mountable package. It is designed specifically for use with SynQor UPS-1250, UPS-1500 and UPS-3000 series uninterruptible power supplies (UPS). It is designed for the extreme environmental and demanding electrical conditions of Military/Aerospace applications.

The pack cannot be used as a standalone battery. Multiple layers of circuit protection are implemented internal to the battery pack. Features include heater resistors for operating down to -40°C ambient, and internal hardware protection and status monitoring.

The BAT-0400-M pack provides cold-start operation down to -40°C. A cold-start is an enable of the UPS using only battery power, with no input power available. Below -20°C, following a cold-start enable command from the user, the BAT-0400 will pre-heat itself to operational temperature, then enable the UPS output.

From a start with the battery pack soaked at -40°C, the cold-start pre-heat takes 3.5 minutes. The pre-heat terminates based on internal cell temperatures, so a cold-start from a temperature warmer than -40°C will take less than 3.5 minutes. Although operation at full output load requires a full pre-heat sequence, the user can optionally set the pre-heat to terminate early if the output load is known to be less than full load.

Specification Compliance

When installed inside a UPS-1250/1500/3000, the system is designed to meet:

  • MIL-STD-1399-300B – Interface Std for Shipboard Systems
  • MIL-STD-810G – Environmental Engineering Considerations
  • MIL-STD-461F – Electromagnetic Interference
  • MIL-STD-704F – Aircraft Electrical Power Characteristics
  • MIL-STD-1275D – Vehicle Electrical Power Characteristic

Compatible with UPS-1250, UPS-1500 & UPS-3000 models
We are offline - Send us an email
Sorry, we are not online at the moment. Please send a message and we'll reply to you. Please include your region so we can connect you with the correct team.
In case we get disconnected, please give us some info so we can follow up with you.
    ×
    File size larger than 50 Mb
    ×
    File type not allowed
    Send chat transcript to your email:
    ×
    Transcript sent!
    Are you sure you want to close this chat?
    Thank you. We would appreciate it if you could rate this chat

    No, thanks